User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Live View Introduction
DVR User Manual
24
5.3.2 Image Settings
Click Start→Settings→Camera→Image→Image Settings to go to the following interface. Select the camera
and then set the brightness, contrast, saturation and hue of the camera. Click “Advanced” button or in
the camera list on the right side of the interface to pop up “Image Adjust” interface and then set the
relevant setting items. Please refer to 5.4.5 Image Adjustment for detailed introductions of these items.
You can click “Default” to restore the image settings to the default factory settings.
5.3.3 Mask Setting
Some areas of the image can be masked for privacy. Up to four mask areas can be set for each camera. Click
Start→Settings→Camera→Image→Mask Settings to go to the interface as shown below. Select the camera
and enable the mask. Click “Draw” button and then drag the mouse on the image area to set the mask area;
click “Delete” button to delete the mask areas; click “Apply” to save the settings.