User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Live View Introduction
DVR User Manual
23
Go to the live view interface and then click to open a window. Set the sequence interval in the window
and then click to start scheme view in sequence. Double click the sequence view interface to pause the
view; double click again to restore the view. Click to stop the view.
5.2.4 Spot View
Click Start→Settings→System→Basic→Output Settings→Output 2 to go to the interface as shown below.
Click on the left to create a new scheme. Each scheme can only add one analog camera. Select a
scheme on the left and then double click or drag a camera on the right to the scheme window in the middle
of the interface. After finishing the settings of all the schemes, select the sequence interval and click “Apply”
to start playing the schemes in sequence in output 2.
5.3 Image Configuration
5.3.1 OSD Settings
Click Start→Settings→Camera→Image→OSD Settings to go to the interface as shown below. Select the
camera, enter the camera name (or double click the camera name in the camera list to change the camera
name), enable or disable the name and time OSDs (if enabled, drag the red name and time OSDs directly in
the image view area to change the OSDs’ display position) and select the date, time format and color. Click
“Apply” to save the settings.