User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Live View Introduction
DVR User Manual
22
mode. Double click the sequence view interface to pause the view; double click again to restore the view.
Click to stop the view.
5.2.3 Scheme View In Sequence
Click Start→Settings→System→Basic→Output Settings to go to the interface as shown below.
Area ① displays all the sequence schemes; area ② shows the detailed information of the scheme; area ③
displays all the cameras and groups; area ④ is the tool bar ( : clear button; : favorite button, click it to
pop up a window, enter the display mode name in the window and then click “OK” to save the current
display mode; other buttons are screen mode buttons).
➢ Add Scheme
Click in area ① to create a new scheme. Click on the top right corner of the scheme to delete it.
➢ Configure Scheme
a) Select a scheme in area ① and then click the screen mode button on the tool bar to set the screen mode of the scheme.
b) Select a camera window in area ② and then double click the camera or group in area ③. The camera or group will be added into the
selected window. One camera in the same scheme cannot repeat. You can click the right-click menu “Clear” in area ② to remove a single
camera or click to remove all the cameras.
c) Click “Apply” to save the settings.
➢ Start Sequence View