User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Live View Introduction
DVR User Manual
21
① Click “Customize Layout” in the above interface and then set the screen mode.
② Add the cameras and adjust the cameras’ display sequence as needed.
③ Click under the display mode list and then enter the display mode name in the popup window, click
the “OK” button to save the current display mode.
Method Two:
① Click Start→Settings→System→Basic→Output Settings to go to the interface and then set the screen
mode.
② Double click the camera or camera group in the list to add them to the selected window.
③ Click to save the current display mode (refer to 5.2.4 Scheme View In Sequence for detail configurations). The
display mode will be saved and displayed in the display mode list in the live view interface.
➢ Edit Display Mode
Click “Customize Layout” tab in the live view interface and then select one display mode in the list. Click
to edit the display mode name; click to delete the display mode.
5.2.2 Quick Sequence View
You can start quick sequence view if the scheme has not been created. If the scheme has been created,
please refer to 5.2.4 Scheme View in Sequence for details.
Go to the live view interface and then click to pop up a little window. Set the dwell time in the window
and then click to view the live group by group according to the camera number of the current screen