User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Live View Introduction
DVR User Manual
17
➢ Quickly Add
Check the cameras and then click “Add” to add cameras. Click to edit the camera’s IP address,
username and password and so on. Click “Default Password” to set the default username and password of
each camera.
➢ Add Manually
Enter the IP address or domain name (click in the IP address column to pop up the domain name input
window, enter the domain name of the IPC in the window and then click “OK” button), port, username and
password of the camera and then select the protocol. Click “Test” to test the effectiveness of the input
information and then click “Add” button (you can input one camera’s information or above such as IP
address, username and password before clicking “Add” button). Click to delete the camera. Click
“Default Password” to set the default username and password of each camera.
4.2.2 Edit Camera
Click “Edit Camera” in the setup panel to go to the interface as shown below. Click to view the live image
of the camera in the popup window. Click to edit the camera (see Add camera in 3.1 Startup Wizard for
details). Click to delete the camera. Click in the “Operation” header line and then click “Modify IPC