User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
EZ Setup & Main Interface
DVR User Manual
12
The buttons in area ① are introduced in the table below.
Button
Meaning
Start button. Click it to pop up area ③.
Full screen button. Click it to show full screen; click it again to exit the full screen.
Screen mode button.
Sequence button (see 5.2.2 Quick Sequence View and 5.2.4 Scheme View in Sequence
for details).
Click it to enable OSD; click again to disable OSD.
Click to set the default playback time before starting instant playback (8.1 Instant
Playback) or going to the playback interface for playback operations (8.2 Playback
Interface Introduction); click to go to the playback interface. For instance, if you
choose “5 minutes ago” as the default playback time, you can playback the record
from the past five minutes.
Manual record button. Click it to enable/disable record.
Manual alarm button. Click it to trigger or clear the alarm-out manually in the popup
window.
Record status button. Click it to view the record status.
Alarm status button. Click it to view the alarm status.
Disk status button. Click it to view the disk status
Network status button. Click it to view the network status.
Information button. Click it to view system information.
Introduction of area ②: