User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
EZ Setup & Main Interface
DVR User Manual
10
Click to edit the searched IP camera as shown on the below left. Enter the new IP address, subnet
mask, gateway, username and the password of the camera. You can check “Sync to IPC” to modify the IP
address of the IPC via different network segments for being in the same network segment with the DVR.
Click “OK” to save the settings.
Click to edit the added camera as shown on the above right. Enter the new camera name, IP address,
port, username and the password of the camera. You can click “Test” to test the effectiveness of the input
information. Click “OK” to save the settings. You can change the IP camera name only when the added
camera is online. Click “Next” to continue.
⑤ Disk Settings. You can view the disk number, disk capacity of the DVR and serial number, R&W status of
the disk. Click “Formatting” to format the disk. Click “Next” to continue.
⑥ Record Settings. Two record modes are available: auto and manual.
Auto: Select one auto mode in the interface as shown below and then click “Next” button to save the settings. Click “Advanced” to self-define
record mode. See 7.1.1 Mode Configuration for details.