User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record& Disk Management
- 8 Playback& Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
EZ Setup & Main Interface
DVR User Manual
9
③ Other Network Settings.
➢ UPnP settings: Check “Enable” in the interface and enter the port of external and then click “Test”. If the
UPnP status were “Invalid UPnP”, the port number may be wrong. Click to modify the port until the
UPnP status turns to “Valid UPnP”. Refer to the following picture. You can view the external IP address of
the DVR. Enter the external IP address plus port in the address bar of your browser to access the DVR.
(Please see 11.1.6 UPnP Configuration for details).
➢ DDNS Settings: Check “Enable” and then select the DDNS type. Enter the server address, domain name,
username and password according to the selected DDNS type. And then click “Register” or “Test” to test
the effectiveness of the domain name. If it is effective, you can enter the domain name in the address bar
of your browser to access the DVR. (Please see 11.1.4 DDNS Configuration for details).
Note: Make sure the router supports UPnP function and the UPnP is enabled in the router. Set the DVR’s IP
address, subnet mask and gateway and so on corresponding to the router.
④ Add Camera. To add cameras from the LAN, make sure all cameras are set to DHCP. Click “Refresh” to
refresh the list of online IP cameras which are in the same local network with DVR and then click to add
the searched camera. Click “Add All” to add all the cameras in the list. Click to delete the added
camera. Click “Delete All” to delete all the added cameras.