User Guide
3
In-Ceiling Mounting for Varifocal Dome Camera
1
2
Attach the drill template to the ceiling where you want to
install the dome camera. Then cut a hole according to the
drill template. Note that +2mm of the circle diameter is
allowed.
Loosen the screws to open the lower dome and then loosen the fixed
screw to remove the mounting base. After that, make sure the screw
holes of the mounting base are aligned with the screw holes of the
bracket marked with “B” and then fix them with screws.
Ø212mm
Tighten the lock screws with the screwdriver and the locks
will automatically rotate outwards to secure the dome camera
to the ceiling. Then adjust the view angle of the camera.
Ceiling
Ceiling
Ceiling
Locks
Screws
Route the cables through the ceiling and connect the cables.
Then push the dome camera with the bracket into the mounting
hole in the ceiling.
Install the magnetic ring of the bracket.
4
3
5
6
Magnetic ring
Trim ring
B
Fixed screw
Lower dome
Screws
Mounting base
Mounting hole
Install the lower dome back to the camera. Then put the trim
ring onto the lower dome and rotate it clockwise until it is
locked.
Page 3