User Guide

ManualsBrandsSpeco ManualsFlush Mountingspeco FMT1 In Ceiling Flush Mounting

Table Of Contents

In-Ceiling Mounting

Quick Start Guide

Thank you for purchasing our product. This manual is applicable to the in-ceiling bracket. All pictures in this

manual are for reference only.

Mounting Examples

Fixed dome camera

Varifocal dome camera

Before installation, please make sure that (1) the height of the space above the ceiling must be more than 250mm; (2) the

thickness of the ceiling must range from 5mm to 40mm; (3) the ceiling must be strong enough to withstand more than four

times the weight of the dome camera and the accessories. The following pictures are for reference only.

Installation

In-Ceiling Mounting for Fixed Dome Camera

Ø180mm

Attach the drill template to the ceiling where you want to

install the dome camera. Then cut a hole according to the drill

template. Note that +2mm of the circle diameter is allowed.

Type A

Type B

Type A

Type B

Remove the lower dome of the camera. Then place the in-ceiling

bracket on the dome camera and tighten the screws provided to fix

the bracket and the dome camera. (For type B, you shall rotate the

trim ring anticlockwise to remove it. Then you can remove the lower

dome by loosening the screws.)

Lower dome

Trim ring

Page 1

Summary of content (4 pages)

PAGE 1
In-Ceiling Mounting Quick Start Guide Thank you for purchasing our product. This manual is applicable to the in-ceiling bracket. All pictures in this manual are for reference only.
PAGE 2
3 Mounting hole 4 Ceiling Ceiling Ceiling Locks Screws Route the cables through the ceiling and connect the cables. Then push the dome camera with the bracket into the mounting hole in the ceiling. Tighten the lock screws with the screwdriver and the locks will automatically rotate outwards to secure the dome camera to the ceiling. Then adjust the view angle of the camera. 5 6 Type A Type B Magnetic ring Trim ring Install the lower dome back to the camera.
PAGE 3
Mounting hole 4 Ceiling Ceiling Ceiling Locks Screws Route the cables through the ceiling and connect the cables. Then push the dome camera with the bracket into the mounting hole in the ceiling. Tighten the lock screws with the screwdriver and the locks will automatically rotate outwards to secure the dome camera to the ceiling. Then adjust the view angle of the camera. 6 5 Magnetic ring Trim ring Install the lower dome back to the camera.
PAGE 4
3 4 Mounting hole Ceiling Screws Locks Fixed screw Route the cables through the ceiling and connect the cables. Then fasten the camera to the mounting base with the fixed screw. After that, push the dome camera with the bracket into the mounting hole in the ceiling. Tighten the lock screws with the screwdriver and the locks will automatically rotate outwards to secure the dome camera to the ceiling. Then adjust the view angle of the camera.