User Guide
Table Of Contents
- Main Features
- Initial Boot up Process
- Name, Function and Connection
- Setting up the DVR
- 4-1. Setup – Main Live Screen
- 4-2. Setup – SYSTEM Mode
- 4-3. Setup – RECORD Mode
- 4-3-1. Recording Schedules
- 4-4. Setup – DEVICE Mode
- 4-5. Setup – DISPLAY Mode
- 4-6. Setup – NETWORK Mode
- 4-6-1. Network Types
- 4-6-2. DDNS
- 4-6-3. Network Port and Web Port
- 4-6-4. Network Stream
- 4-7. Setup – USER MANAGEMENT Mode
- 4-8. Setup – STORAGE Mode
- 4-9. Setup - CONFIG Mode
- 4-9-1. Firmware Upgrade
- Live, Search and Playback
- Export and Back Up
- Network Access Using the Multi-Sites Network Viewer
- 7-1. Overview
- 7-2. PC Requirements
- 7-3. Installation of the Program
- 7-4. Live Window
- 7-4-1. Main User Interface
- 7-4-2. Control Buttons
- 7-5. Search and Playback Window
- 7-5-1. Main User Interface
- 7-5-2. Main Control Panel
- 7-6. Setup of SpecoTech Multi Client
- 7-6-1. General
- 7-6-2. Event
- 7-6-3. Record
- 7-6-4. Display
- 7-6-5. Language
- 7-6-6. About
- 7-7. Remote Setup
- 7-7-1. System
- 7-7-2. Record
- 7-7-3. Device
- 7-7-4. Display
- 7-7-5. Network
- 7-7-6. User Management
- 7-7-7. Storage
- 7-7-8. Remote Upgrade
- 7-8. Operation
- 7-8-1. Addition, Delete, and Modify of DVR Sites
- 7-8-2. Connect and Disconnect
- 7-8-3. Still-image Capture During Live
- 7-8-4. Recording Video on Local PC During Live
- 7-8-5. Local Playback and Remote Playback
- 7-8-6. AVI Backup during Playback
- Network Access Using the Web-Browser Viewer
- Network Access Using the Smart Phone Viewer
- APPENDIX: Network Connection - LAN
- APPENDIX: Network Connection – Internet and DDNS
35
4-4-4. Motion Zone Setup
Select MOTION ZONE using the mouse or the remote control and select either PARTIAL ZONE or FULL
ZONE using the mouse control. The default value is FULL ZONE.
If FULL ZONE is selected, the motion zone grid screen is not displayed. Only set the level of sensitivity for
MOTION SENSITIVITY.
FULL ZONE: The motion sensor is active on the whole screen.
PARTIAL ZONE: The motion sensor is active in the set detection frame.
Select the motion detection position using the mouse or the remote control. Then left click on the mouse or
left click and drag the mouse pointer to select or deselect the area. Highlighted area indicates the partial
motion detection zone. Press the ESC button or right click on the mouse to return to the previous menu.
Figure 4.4.8. Motion Zone Grid Screen