User Guide
Table Of Contents
- Main Features
- Initial Boot up Process
- Name, Function and Connection
- Setting up the DVR
- 4-1. Setup – Main Live Screen
- 4-2. Setup – SYSTEM Mode
- 4-3. Setup – RECORD Mode
- 4-3-1. Recording Schedules
- 4-4. Setup – DEVICE Mode
- 4-5. Setup – DISPLAY Mode
- 4-6. Setup – NETWORK Mode
- 4-6-1. Network Types
- 4-6-2. DDNS
- 4-6-3. Network Port and Web Port
- 4-6-4. Network Stream
- 4-7. Setup – USER MANAGEMENT Mode
- 4-8. Setup – STORAGE Mode
- 4-9. Setup - CONFIG Mode
- 4-9-1. Firmware Upgrade
- Live, Search and Playback
- Export and Back Up
- Network Access Using the Multi-Sites Network Viewer
- 7-1. Overview
- 7-2. PC Requirements
- 7-3. Installation of the Program
- 7-4. Live Window
- 7-4-1. Main User Interface
- 7-4-2. Control Buttons
- 7-5. Search and Playback Window
- 7-5-1. Main User Interface
- 7-5-2. Main Control Panel
- 7-6. Setup of SpecoTech Multi Client
- 7-6-1. General
- 7-6-2. Event
- 7-6-3. Record
- 7-6-4. Display
- 7-6-5. Language
- 7-6-6. About
- 7-7. Remote Setup
- 7-7-1. System
- 7-7-2. Record
- 7-7-3. Device
- 7-7-4. Display
- 7-7-5. Network
- 7-7-6. User Management
- 7-7-7. Storage
- 7-7-8. Remote Upgrade
- 7-8. Operation
- 7-8-1. Addition, Delete, and Modify of DVR Sites
- 7-8-2. Connect and Disconnect
- 7-8-3. Still-image Capture During Live
- 7-8-4. Recording Video on Local PC During Live
- 7-8-5. Local Playback and Remote Playback
- 7-8-6. AVI Backup during Playback
- Network Access Using the Web-Browser Viewer
- Network Access Using the Smart Phone Viewer
- APPENDIX: Network Connection - LAN
- APPENDIX: Network Connection – Internet and DDNS
33
Figure 4.4.4. Device Mode Setup Screen
② Open the PTZ sub menu by selecting the submenu button.
Figure 4.4.5. PTZ Control Setup Screen
Note: Connect PTZ cameras that support RS-485 directly to the RS-485 port. If the camera is controlled
through an RS-232C interface, use an RS-232C to RS-485 to RS-232C signal converter.
Use the PTZ setup screen to select the following options for the camera PTZ controller:
- CHANNEL: Channel connected to a PTZ device
- CAMERA: Protocol Type
- SPEED: 19200, 14400, 9600, 4800, 2400 (Baud rate)
- ID: 0-63
Controller (Keyboard Controller): If a PTZ controller is used, select a controller protocol from Controller
menu. Set SPEED (Baud Rate) and ID number.
Figure 4.4.6. Controller Selection Screen