User Guide
Table Of Contents
- Main Features
- Initial Boot up Process
- Name, Function and Connection
- Setting up the DVR
- 4-1. Setup – Main Live Screen
- 4-2. Setup – SYSTEM Mode
- 4-3. Setup – RECORD Mode
- 4-3-1. Recording Schedules
- 4-4. Setup – DEVICE Mode
- 4-5. Setup – DISPLAY Mode
- 4-6. Setup – NETWORK Mode
- 4-6-1. Network Types
- 4-6-2. DDNS
- 4-6-3. Network Port and Web Port
- 4-6-4. Network Stream
- 4-7. Setup – USER MANAGEMENT Mode
- 4-8. Setup – STORAGE Mode
- 4-9. Setup - CONFIG Mode
- 4-9-1. Firmware Upgrade
- Live, Search and Playback
- Export and Back Up
- Network Access Using the Multi-Sites Network Viewer
- 7-1. Overview
- 7-2. PC Requirements
- 7-3. Installation of the Program
- 7-4. Live Window
- 7-4-1. Main User Interface
- 7-4-2. Control Buttons
- 7-5. Search and Playback Window
- 7-5-1. Main User Interface
- 7-5-2. Main Control Panel
- 7-6. Setup of SpecoTech Multi Client
- 7-6-1. General
- 7-6-2. Event
- 7-6-3. Record
- 7-6-4. Display
- 7-6-5. Language
- 7-6-6. About
- 7-7. Remote Setup
- 7-7-1. System
- 7-7-2. Record
- 7-7-3. Device
- 7-7-4. Display
- 7-7-5. Network
- 7-7-6. User Management
- 7-7-7. Storage
- 7-7-8. Remote Upgrade
- 7-8. Operation
- 7-8-1. Addition, Delete, and Modify of DVR Sites
- 7-8-2. Connect and Disconnect
- 7-8-3. Still-image Capture During Live
- 7-8-4. Recording Video on Local PC During Live
- 7-8-5. Local Playback and Remote Playback
- 7-8-6. AVI Backup during Playback
- Network Access Using the Web-Browser Viewer
- Network Access Using the Smart Phone Viewer
- APPENDIX: Network Connection - LAN
- APPENDIX: Network Connection – Internet and DDNS
27
4-3. Setup – RECORD Mode
In the SETUP menu, select the RECORD tab. Then, the RECORD menu is displayed as pictured below.
Navigate through the menu items or change the settings using the mouse or the remote control.
Figure 4.3.1. RECORD Setup Screen
Table 4.3.1. Menu Items in RECORD Setup Screen
Menu Item Description
SITE
Select a channel for applying the following settings using the mouse or the remote
control.
To change the values of all channels, take the following steps. Select the
following to change the values of all channels.
RESOLUTION
Select 960H, D1 or CIF using the mouse or the remote control.
FRAME RATE
Set the frame rate for the specified channel. The sum of the frame rate values from
each channel cannot exceed the maximum frame rates for a specific recording
resolution.
QUALITY
Select the recording quality for the selected channel. Options are;
Level 1 (Low), Level 2, Level 3, Level 4, and Level 5 (High)
RECORDING
MODE
Assign the recording mode for the selected channel. Options are: Continuous,
Motion, Sensor, Schedule or Disable.