User Guide

SEQUENCE

DWELL TIME

Set the dwell time for the spot channel display. (1-10sec)

SPOT CHANNEL

Select a channel for spot monitoring using the mouse or the remote

control and press OK button.

4-4-5. Motion Zone Setup

Select MOTION ZONE using the mouse or the remote control and select either PARTIAL ZONE or FULL

ZONE using the mouse control. The default value is FULL ZONE.

If FULL ZONE is selected, the motion zone grid screen is not displayed. Only set the level of sensitivity for

MOTION SENSITIVITY.

FULL ZONE: The motion sensor is active on the whole screen.

PARTIAL ZONE: The motion sensor is active in the set detection frame.

Select the motion detection position using the mouse or the remote control. Then left click on the mouse or

left click and drag the mouse pointer to select or deselect the area. Highlighted area indicates the partial

motion detection zone. Press the ESC button or right click on the mouse to return to the previous menu.

Figure 4.4.5. Motion Zone Grid Screen