Quick Start Guide O2P25X
Welcome Thank you for purchasing this PTZ camera! This owner's manual is designed to be a reference tool for your system. Please read this manual carefully before operating the unit and retain it for future reference. Should you require any technical assistance, contact Speco Technologies Tech Support at 1-800-645-5516 Important Safeguards and Warning 1. Electrical safety All installation and operation here should conform to local electrical safety codes. Use a certified/listed 24VDC/AC power supply only.
dampened with a small quantity of neutral detergent. Finally use the dry cloth to clean the device. Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may result in poor IR functionality and/or IR reflection. The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera. Warning This camera should be installed by qualified personnel only.
Overview 31 Overview 1 2 3 1 Ethernet connector 2 Power connector 3 Safety wire 2 Cable Connection N e tw o DC12V rk C a b le
► Connecting Network Cable 2 1 3 ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through the both elements. Then crimp the cable with RJ 45 connector. ③ Connect the cable to the water-proof connector. Then tighten the nut and the main cover. 3 Installation Please make sure the wall is strong enough to bear the dome camera’s weigh and the camera is powered off during installation. This PTZ camera supports wall or ceiling mounting.
Micro SD Card Installation Insert a micro SD card 1. Loosen the four screws of the cover and then remove the cover. 2. Insert a micro SD card as indicated above and then install the cover back. Wall Mounting 1. Pull the cables through the 2. Secure the PTZ camera to the bracket. bracket with screws.
3. Drill the screw holes on the wall 4. Insert two screws to the holes according to the drill template. Then as indicated by the arrows (left) insert the plastic plugs into the holes. and leave 12mm clearance. 12 5. Connect the cables and then 6. Attach the bracket to the wall hang the bracket on the wall. with four screws.
4 Web Operation and Login IP Scanner can search for the device on the local network. ● Operation ① Make sure that the camera and the PC are connected to the same local network. The camera is set to DHCP by default. ② Install IP Scanner from the CD and run it after installation. O2P25X 5C:F2:07:24:68:B9 ③ In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer.
