Installation Guide

8
Paste a Drilling Template on the ceiling. (or wall)
Drill screw points which will be done for installation.
Fix the plastic anchors in the holes. (in case of masonry ceiling or wall)
Mount the camera set by using Tapping Screws with Ø4 provided.
Set the position and angle of the cameras to a desired direction and assemble the dome cover.
Ceiling_Junction Box
1) Attach the Sponge on Junction Box
2) Mark the hole of Junction box on the ceiling with Tapping Screw
3) Drill the hole and input the anchor. And install the Junction Box with Tapping Screw
4) Input Cable inside Junction Box
5) Install Bottom Ass'y on Junction Box with PH M4X12
6) Install Top Case Ass'y on Bottom Ass'y with L_Wrench
Ceiling Tile
Plastic Anchor x 4
Junction Base Sponge
Junction Box Assembly
Tapping Screw (Ø4 x 30) x 4
Bottom Ass'y
Safety Wire
PH (M4 x 12) x 3
Top Case Ass'y
L-Wrench