Quick Start Guide O6MDP3N
Welcome Thank you for purchasing this network camera! This owner's manual is designed to be a reference tool for your system. Please read this manual carefully before operating the unit and retain it for future reference. Should you require any technical assistance, contact Speco Technologies Tech Support at 1-800-645-5516 Important Safeguards and Warning 1. Electrical safety All installation and operation here should conform to local electrical safety codes.
dampened with a small quantity of neutral detergent. Finally use the dry cloth to clean the device. Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may result in poor IR functionality and/or IR reflection. The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera. Warning This camera should be installed by qualified personnel only.
CD 2 Tapping screws ×3 Plastic plug × 3 Junction box Overview 1 2 3 4 5 6 7 8 9 DC12V 1 2 3 4 Ethernet Connector MIC IN HP Audio Output Video Output 5 6 7 8 9 Alarm Input/Output RS485 DC12V Power Supply SD Card Slot Reset RS485T+ RS485T- ALM-COM ALM-OPEN ALM-INA ALM-GND
* 1 It is recommended to install the security cap for outdoor installations. * 2 DC 12V power supply is not required if a PoE switch or injector is used to power the camera. ● Connecting Network Cable 2 1 3 ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through the both elements. Then crimp the cable with RJ 45 connector. ③ Connect the cable to the water-proof connector. Then tighten the nut and the main cover.
Fixed Ring Gap ② Install the junction box onto the wall. ③ Route the cables through the cable hole (take side conduit cabling for example) and connect the cables. Then fix the camera onto the junction box with screws.
Rubber plug ④ Install the fixed ring back to finish the installation. 4 Web Operation and Login IP Scanner can search for the device on the local network. ● Operation ① Make sure that the camera and the PC are connected to the same local network. The camera is set to DHCP by default.
② Install IP Scanner from the CD and run it after installation. O6MDP3N 5C:F2:07:24:68:B9 ③ In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer. You can also manually enter the IP address in the address bar of the web browser. The login interface is shown above. Default user name is admin and password is 1234. After logging in, follow directions to install applicable plugins.
