Quick Start Guide O4FD1
Welcome Thank you for purchasing this network camera! This owner's manual is designed to be a reference tool for your system. Please read this manual carefully before operating the unit and retain it for future reference. Should you require any technical assistance, contact Speco Technologies Tech Support at 1-800-645-5516 Important Safeguards and Warning 1. Electrical safety All installation and operation here should conform to local electrical safety codes.
dampened with a small quantity of neutral detergent. Finally use the dry cloth to clean the device. Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may result in poor IR functionality and/or IR reflection. The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
Camera Quick start guide CD 4 tapping screws Drill template Plastic plug ×4 Junction box Screwdriver Rubber plug 4321 ALARM Overview 32 Overview 5 1 1 Ethernet connector 2 2 Audio input connector 3 4 3 Alarm input/output 4 Power connector 6 5 Microphone 7 6 Micro SD Card Slot 7 Reset
ro Wat er-p of co nn ec to r 4321 ALARM 1--ALM-COM 2--ALM-OPEN 3--ALM-INA 4--ALM-GND DC12V * 1 It is recommended to install the water-proof connector for outdoor installations. * 2 DC 12V power supply is not required if a PoE switch or injector is used to power the camera. ► Connecting Network Cable 1 2 3 ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through both elements. Then crimp the cable with RJ 45 connector.
3 Installation * Before you start, please make sure that the wall or ceiling is strong enough to withstand three times the weight of the camera. ① Install junction box onto the wall by using the screws provided. ② Rotate the trim ring anticlockwise to remove it from the camera. Trim ring ③ Loosen the screws to open the lower dome.
Lower dome ④ Connect the cables, mount the rubber plug to the gap of the mounting base and fasten the camera onto the junction box. Rubber Plug ⑤ Three-axis adjustment. Before adjustment, view the image of the camera on a monitor and then adjust the camera according to the figure below to get an optimum angle.
Pan 0°~355° Rotation 0°~355° Tilt 0°~67° ⑥ Install the lower dome back to the camera and fasten it with the screws. Then put the trim ring onto the lower dome and then rotate it clockwise until it is locked. 4 Web Operation and Login IP Scanner can search for the device on the local network.
① Make sure that the camera and the PC are connected to the same local network. The camera is set to DHCP by default. ② Install IP Scanner from the CD and run it after installation. Or download from https://www.specotech.com/ip-scanner/ O4FD1 5C:F2:07:24:58:9A ③ In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer.
