Quick Start Guide O4FB1M
Welcome Thank you for purchasing this network camera! This owner's manual is designed to be a reference tool for your system. Please read this manual carefully before operating the unit and retain it for future reference. Should you require any technical assistance, contact Speco Technologies Tech Support at 1-800-645-5516 Important Safeguards and Warning 1. Electrical safety All installation and operation here should conform to local electrical safety codes.
dampened with a small quantity of neutral detergent. Finally use the dry cloth to clean the device. Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may result in poor IR functionality and/or IR reflection. The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera. Warning This camera should be installed by qualified personnel only.
CVBS&DC Drill Template 4 tapping screws 1 machine screw Screwdriver IN cables Plastic plug × 4 Junction box Overview 32 Overview 1 432 1 ALA RM 2 3 4 5 6 7 8 9 10 11 1 Ethernet Connector * 2 Audio Input (MIC) 3 Audio Output (HP) 4 CVBS Video Output 5 Alarm Input/Output 6 Power Connector * 7 Reset* 8 DC IN&CVBS Interface 9 Zoom - 10 Zoom + 11 Micro SD Card Slot
r to ec nn co of ro -p er W at 43 AL AR 21 M 1--ALM-COM 2--ALM-OPEN 3--ALM-INA 4--ALM-GND 12VDC/24VAC * 1 It is recommended to install the water-proof connector for outdoor installations. * 2 DC 12V/AC24V power supply is not required if a PoE switch or injector is used to power the camera. ► Connecting Network Cable 1 2 3 ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through both elements. Then crimp the cable with RJ 45 connector.
3 Installation * Before you start, please make sure that the wall or ceiling is strong enough to withstand three times the weight of the camera. ① Open the mounting base and the upper cover of the junction box. Mounting base Upper cover ② Install junction box onto the wall by using the screws provided. ③ Fix the mounting base of the camera to the upper cover of the junction box.
④ Route the cables through the cable hole and connect the camera. Then install the camera onto the mounting base of the junction box. ⑤ Three-axis Adjustment-Before adjustment, preview the image of the camera on a monitor and then loosen the fixed screws to adjust the camera according to the figure below to get an optimum angle.
Fixed screws Pan 360° Tilt 90° Rotate 360° 4 Web Operation and Login IP Scanner can search for the device on the local network. ● Operation ① Make sure that the camera and the PC are connected to the same local network. The camera is set to DHCP by default. ② Install IP Scanner from the CD and run it after installation.Or download from https://www.specotech.com/ip-scanner/ O4FB1M 5C:F2:07:24:68:B9 ③ In the device list, you can view the IP address, model number, and MAC address of each device.
The login interface is shown above. Default user name is admin and password is 1234. After logging in, follow directions to install applicable plugins if prompted.
