User's Manual

SMT User Manual

Record & Disk Management

Go to “Edit Schedules” interface and then click to edit the schedule. The settings of “Edit

Schedule” are similar to that of the “Add Schedule”. Click to delete the schedule.

9.4

Record Mode

9.4.1 Manual Recording

Method One: Click on the tool bar at the bottom of the live preview interface to enable

recording of the camera.

Method Two: Go to live preview interface and then click the right-click menu “Manually

Record On” in the camera window or click on the tool bar under the camera window to

start recording.

9.4.2 Timing Recording

Timing Recording: the system will record automatically according to the schedule.

Set the timing record schedule of each camera. See 9.3 Schedule Settings for details.

9.4.3 Motion Based Recording

Motion Based Recording: the system will start motion based recording when the motion

object appears in the setup schedule. The setup steps are as follows:

① Set the motion based recording schedule of each camera. See 9.3 Schedule Settings for

details.

② Enable the motion and set the motion area of each camera. See 11.4.1 Motion

Configuration for details.

The camera will start motion based recording once you finish the above settings.

9.4.4 Sensor Based Recording

① Set the sensor based recording schedule of each camera. See 9.3 Schedule Settings for

details.

② Set the NO/NC type of the sensor, enable the sensor alarm and then check and configure

the “Record”. See 11.3 Sensor Alarm for details.

9.4.5 Intelligence Recording

① Set the intelligence recording schedule of each IP camera. See 9.3 Schedule Settings for

details.

② Enable and set the intelligence detection (over temperature, non-mask detection, etc.) See

Note: Click Start Settings Record Mode Settings and then set the manual record time in the

interface. Click “Apply” to save the settings.