User's Manual

SMT User Manual
Live View Introduction
28
enabled in the IP cameras/panels.
b. The non-mask detection alarm of the SMT shall be enabled in advance (Click
StartSettingsAI/EventMask Settings to go to the mask settings interface and then enable
it. See 11.2 Mask Settings for details).
3. The added IP cameras/panels must support temperature measurement, or the body
temperature will not be shown here. Please click StartSettingsAI/EventBody
Temperature Settings to go to the body temperature settings interface and then set the
temperature threshold. See 11.1 Body Temperature Settings for details).
 Real-time Warning
Click to view the real-time warning records as shown below.
All exception events will be shown under this tab, such as mask off, over temperature or
blacklist.
Click to display more menus.
Click “Settings” to choose “Current Cameras” or “All Cameras”.
If “Current Cameras” is selected, the real-time warning interface and intelligent
detection interface in live view mode will only show the face match result of the
current cameras.
Click “More” to go to the “Pass-Through Records” interface.
 Real-Time Statistics Display
In the live display interface, you can directly view the real-time statistical information as
shown below.