User's Manual

SMT User Manual

Device Management

Device Name: The name of the device. It may display on the client end or CMS that help user

to recognize the device remotely.

Video Format: Two modes: PAL and NTSC. Select the video format according to the camera.

Main Output: Enable “Fixed display resolution” and then select the main output as needed.

Note: You can set the resolutions of the main output and secondary output respectively if the

SMT has dual outputs. Refer to the picture as shown below.

Dwell Automatically: Switch automatically. Check it and set “wait time”.The system will

switch images automatically if it is not operated during the time you set.

13.2.2 Date and Time Configuration

Click StartSettingsSystemBasicDate and Time to go to the interface as shown below.

Set the system time, date format, time format and time zone of the SMT. The default time zone

is GMT+08 Beijing, Hong Kong, Shanghai, Taipei. If the selected time zone includes DST, the

DST of the time zone will be checked by default. Click “Apply” to save the settings.

You can manually set the system time or synchronize system time with network through NTP.

Manual: select “Manual” in the “Synchronous” option and then click after the “System

Time” option to set the system time.

NTP: select “NTP” in the “Synchronous” option and then enter the NTP server.