User's Manual

SMT User Manual
Device Management
91
13.1.10 SNMP
① Click StartSettingsNetworkSNMP to go to the interface for SNMP configuration.
② Check SNMPv1or SNMPv2 to enable this function.
③ Set the port of the SNMP.
④ Set the trap address and the trap port.
⑤ Click “Apply” to save the settings.
Trap Address: The IP address of SNMP host.
Trap Port: The port of SNMP host.
Tips: Before setting the SNMP, please download the SNMP software and manage to receive
the device information via SNMP port. By setting the trap address, the device is allowed to
send the alarm event and exception message to the monitoring center.
13.1.11 View Network Status
Click StartSettingsNetworkNetwork Status to view the network status or click on
the tool bar at the bottom of the live preview interface to view network status conveniently.
13.2 Basic Configuration
13.2.1 Common Configuration
Click StartSettingsSystemBasicGeneral Settings to go to the following interface. Set
the device name, device No., language, video format and main output. Enable or disable wizard,
“Log In Automatically”, “Log Out Automatically” (if checked, you can set the wait time),
“App Live Self-Adaption” and “Dwell Automatically” (if checked, you can set the wait time).
Click “Apply” to save the settings.