User's Manual

SMT User Manual
Device Management
88
the settings (you don’t have to enter the username and password if “Anonymous Login” is
enabled). Click “Test” to pop up a window. Enter the e-mail address of the recipient in the
window and then click “OK”. The e-mail address of the sender will send an e-mail to the
recipient. If the e-mail is sent successfully, it indicates that the e-mail address of the sender is
configured correctly.
Click “Edit Recipient” to go to the following interface.
Click “Add” and then enter the recipient’s e-mail address and select the schedule (if a schedule
is selected, the system will send the alarm email and the recipient will receive it only in the
selected schedule time) in the popup window. Click “Add” in the window to add the recipient.
You can also change the recipient’s receiving schedule by clicking in the “Schedule”
column. Click to delete the recipient in the list. Click “Apply” to save the settings. Click
“Edit Sender” to go to the e-mail configuration interface of the sender.
13.1.6 UPnP Configuration
By UPnP you can access the SMT through web client which is in WAN via router without port
mapping.
① Click StartSettingsNetworkUPnP to go to the following interface.
② Make sure the router supports UPnP function and the UPnP is enabled in the router.
③ Set the SMT’s IP address, subnet mask and gateway and so on corresponding to the router.
④ Check “Enable” in the interface as shown below and then click “Apply”.