User's Manual

SMT User Manual
AI/Event Management
67
11.3 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each
camera and then set up the alarm handling of each camera.
① Click StartSettingsAI/Event Sensor to go to the following interface.
② Select the alarm type (NO or NC) according to trigger type of the sensor.
③ Enable the sensor alarm of each camera and select the schedule.
④ Check the “Duration”, “Record”, “Snapshot”, “Push”, “Alarm-out” and enable or disable
the “Buzzer”, “Pop-up Video”, “Pop-up Message Box” and “E-mail” as required.
⑤ Click “Apply” to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Duration: it refers to the interval time between the adjacent motion detections. For instance, if
the duration time is set to 10 seconds, once the system detects a motion, it will go to alarm and
would not detect any other motion (specific to camera) in 10 seconds. If there is another motion
detected during this period, it will be considered as continuous movement; otherwise it will be
considered as a single motion.
Record: check it and then the “Trigger Record” window will pop up automatically (you can
also click the “Configure” button to pop up the window). Select camera on the left side and
then click to set the camera as the trigger camera. Select trigger camera on the right side
and then click to cancel the trigger camera. Click “OK” to save the settings. The trigger
cameras will record automatically when the sensor alarm is triggered.
Snapshot: check it and then the “Trigger Snapshot” window will pop up automatically.
Configure the trigger camera in the window. The trigger cameras will capture images