User's Manual

SMT User Manual
Record & Disk Management
53
The camera will start intelligence recording once you finish the above settings. This function
is only available for some devices.
9.5 Disk
9.5.1 Disk Management
 Disk Management
Click StartSettingsDiskDisk Management to go to disk management interface. You can
view the SMT’s disk number and disk status and so on in the interface. Click “Format” to
format the HDD.
Data Encryption:
① Click “Data Encrypt”.
② Enter the username and password used to log in the SMT. This username and password
shall have the permission of disk management.
③ Check the disk you want to encrypt and then enter the password.
After you encrypt the data of a disk, this disk cannot be read by other SMTs unless it is
unlocked.
Data Decryption:
① Click “Change Encrypt”.
② Enter the username and password used to log in the SMT. This user shall have the
permission of disk management.
③ Check the disk you want to decrypt and then empty the password.
④ Click “Close Encrypt”.
Unlock the disk: when one encrypted disk is transferred from another SMT to this SMT, it will
be in locked status. Then you can select this locked disk and click “Unlock”. After you enter
the password of its data encryption, its status will be “Read Only”. Now you can read the data
of this disk but it cannot be written anything.
9.5.2 Storage Mode Configuration
Click StartSettingsDiskStorage Mode to go to the interface as shown below.