User's Manual

SMT User Manual
Record & Disk Management
50
 Set Week Schedule
Click or and then click “Manual” beside to set the week schedule. Refer to
the picture below. Set the start and end time, check the days in the window and then click “OK”
to save the settings.
Click “All” to set all week recording; click “Reverse” to swap the selected and unselected time
in a week; click “Clear All” to clear all the selected area in a week.
9.3.2 Record Schedule Configuration
Click StartSettingsRecordRecord ScheduleSchedule Configuration to go to the
interface as shown below. Only when the record mode is set to “Manual” mode, can this
function be activated. Set the schedule of sensor record, motion record, timed record and
analytics record. Click “None” in the drop-down menu to clear the schedule. Click “Apply” to
save the settings.