User's Manual

SMT User Manual
Wizard & Main Interface
17
Click to edit the searched IP camera as shown on the below left. Enter the new IP
address, subnet mask, gateway, username and the password of the camera. Click “OK” to save
the settings.
Click to edit the added camera as shown on the above right. Enter the new camera name,
IP address, port, username and the password of the camera. You can check “Sync to IPC” to
modify the IP address of the IPC via different network segments for being in the same network
segment with the SMT. Then click “Test” to test the connection. Click “OK” to save the
settings. You can change the IP camera name only when the added camera is online. Click
“Next” to continue.
⑦ Record Settings. Two record modes are available: auto and manual.
Auto: Select one auto mode in the interface as shown below and then click the “Next” to save
the settings. Click “Advanced” to self-define record mode. See 9.1.1 Mode Configuration for
details.