User's Manual

SMT User Manual

Remote Surveillance

14.3

Web WAN Access

 NAT Access

① Set the network of the SMT. Please refer to 13.1.1 TCP/IP Configuration for details.

② Enable NAT and then set the NAT server address. Please refer to 13.1.8 NAT

Configuration for details.

③ Open a web browser on your computer, enter the NAT server address

connect.specotech.cloud in the address bar and then press enter to go to the interface as

shown below (download and install the plug-in according to the tip if you access the SMT

through NAT for the first time).

Notes: 1. Please make sure that the IP address of the SMT and the computer are both in the same

local network segment. For example, supposing that the IP address of the computer is

192.168.1.41, the IP address of the SMT shall be set to 192.168.1.XXX.

2. If the HTTP port of the SMT is not 80, but other number instead, you need to enter the IP

address plus port number in the address bar when accessing the SMT over network. For

example, the HTTP port is 81. You should enter http://192.168.1.42:81 in the address bar.