User's Manual
SMT User Manual
Device Management
89
Click the “Refresh” button to refresh the UPnP status. If the UPnP status is “Invalid UPnP”
after refreshing it a few times, the port number may be wrong. Please change the mapping type
to “Manual” and then click to modify the port until the UPnP status turns to “Valid
UPnP”. Refer to the following picture. You can view the external IP address of the SMT. Enter
the external IP address plus port in the address bar to access the SMT such as
http://183.17.254.19:81.
13.1.7 802.1X
If it is enabled, the SMT data can be protected. When the SMT is connected to the network
protected by the IEEE 802.1X, user authentication is needed.
To use this function, the SMT shall be connected to a switch supporting 802.1x protocol. The
switch can be considered as an authentication system to identify the device in a local network.
If the SMT connected to the network interface of the switch has passed the authentication of
the switch, it can be accessed via the local network.
Protocol type and EAPOL version: Please use the default settings.
User name and password: The user name and password must be the same with the user name
and password applied for and registered in the authentication server.
13.1.8 NAT Configuration
Click StartSettingsNetworkNAT to go to the interface for NAT configuration. Check
“Enable” and then select the NAT server address. Click “Apply” to save the settings.
You can scan the QRCode through mobile client which is installed in the mobile phone or
tablet PC to log in the mobile client instantly.