Home Security System User Manual

37X Speed Dome Camera 36/50
 Alarm Input Setup
ALARM INPUT SETUP
------------------------
ALARM NO. 1
TYPE N.OPEN
ACTION NOT USED
HOLD TIME ENDLESS
POST ACTION HOME
BACK
EXIT
Defines Alarm Function. When an alarm is receive, an
input signal to the camera triggers the user-defined action
programmed for the alarm.
z Alarm No [1~3]
Selects a sensor number to set up.
z Type [Normal OPEN/Normal CLOSE]
Selects sensor operation type.
z Action [NOT
USED/PRESET/PATTERN/SWING/GROUP]
Selects an action to run when a sensor
signal is input.
z Hold Time [ENDLESS / 1~59 SEC. / 1~180 MIN.]
Sets the time period for the action which is
run by external sensor activation. After the
time period passes, the action pre-defined
in “Post Action” runs sequentially in
succession to the action by external sensor
activation. If this option is set to
“ENDLESS”, “Post Action” does not
activate.
z Post Action
[HOME/PRESET/PATTERN/SWING/GROUP
/PREV ACTION]
Selects the action that a camera will run
after the time period in“HOLD TIME”
passes. If Post Action is set to “PREV.
ACTION”, the camera runs the previous
action which it ran most recently.
OSD MENU 4