Home Security System User Manual

37X Speed Dome Camera 20/50

Preset

z Function MAX. 127 positions are programmable. The Preset number can be

assigned from 1 to 128 except 95. Preset 95 is reserved for entering

into OSD menu. Camera parameters such as White Balance, Auto

Exposure and others can be set up independently and each preset

can have its own parameter values independently from the other

persets. When setting up presets with a controller, Label should be

blank and "Camera Adjust" should be set to "GLOBAL" as the

default. To change the parameters, enter into OSD menu.

z Setting Presets Set Preset [1~128]

z Running Presets Go Preset [1~128]

z Deleting Presets To delete Presets, enter into OSD menu.

Swing

z Function This function is that the camera moves repetitively between two

preset positions at programmed speeds. When a swing function

runs, the camera moves from the preset assigned as the 1st point to

the preset assigned as the 2nd point in CW(Clockwise) direction.

Then the camera moves from the preset assigned as the 2nd point to

the preset assigned as the 1st point in CCW(Counterclockwise)

direction.

In case that the preset assigned as the 1st point and the preset

assigned as the 2nd point are same, the camera turns on its axis by

360° in CW(Clockwise) direction and then it turns back on its axis by

360° in CCW(Counterclockwise) direction. The Swing speed is

defined from 1°/sec to 180°/sec.

z Setting Swings To set Swing, enter into OSD menu.

z Running Swings

Method 1) <Run Pattern> [Swing NO. + 10]

Method 2) <Go Preset> [Swing NO. + 140]

ex) Run Swing 3 : <Run Pattern> [13]

ex) Run Swing 3 : <Go Preset> [143]

z Deleting Swings To delete Swings, enter into OSD menu.

1st Preset

2nd Preset

CCW

OPERATION 3