User guide

MARK
/
(15,20,22) TEMPLATE
(for flush mounting)
TOOLS AND MATERIALS NEEDED: Slotted screwdriver, Wire cutter/strippers, Keyhole saw or saber saw, Pencil, scratch awl or other marker Wire of proper gauge to run from the panels, to the MARK/(15,20), and to the battery (See INSTALLATION INSTRUCTIONS #6: WIRE TYPE / SIZE)
Mounting fasteners of appropriate type for wall material Included are four 3/4 - #6 screws and a spare fuse (20 amp AGC for the MARK/15). (25 amp AGC for the MARK/20,22).
Also for Flush Mounting: Also for wall mounting: (MARK/(15,20,22) with 4X7 BOX):
Drill with 3/32" and 3/8" bits 1/2 inch Romex strain relief clamps
Installation steps:
1. Tape template to surface where the MARK/(15,20,22) is to be installed. 2. Punch “Mounting Holes” and “Cutout Corner Holes” with nail or awl. 3. Remove template. Drill “Cutout Corner Holes” with 3/8” drill. Drill “Mounting Holes” with 3/32” drill. 4. Connect outside edge of “Cutout Corner Holes” with a pencil line. 5. Use suitable saw to cut along pencil line. 6. Make electrical connections. (Refer to instruction manual) 7. Mount the MARK/(15,20,22) to wall using supplied wood screws or other appropriate hardware.
Mounting Holes
(1 of 4 )
Cutout Corner Holes
(1 of 4 )
Cutout Outline