Instruction Manual
22 AFTER SALES SUPPORT 0345 605 2067
TROUBLESHOOTING
Suspected malfunctions are often due to issues that the user can x themselves.
Therefore, check the product using this section. In most cases the problem can be
solved quickly.
WARNING! Only perform the steps described within these instructions! All
further inspection, maintenance and repair work must be performed by an
authorised service centre or a similarly qualied specialist if you cannot
solve the problem yourself!
Problem Possible Cause Solution
1. Product does not
start
• Not connected to power supply
• Power cord or plug is defective
• Other electrical defect to the
product
• Connect to a proper power
supply.
• Call after sales support at
0345 605 2067
• Call after sales support at
0345 605 2067
2.Product does not
reach full power
• Extensino cord is not suitable
for this product
• Power source (e.g. generator)
has too low a voltage
• Air vents are blocked
• Use a proper extension
cord
• Connect to another proper
power supply
• Clean the air vents
3. Unsatisfactory result
• Line spool does not have
sufcient line
• Line has not been conducted
out of the spool or only one
seide
• Lengthen cutting line or
exchange a new spool
• Remove spool and place
line through opening
outwards