Instruction Manual

22
AFTER SALES SUPPORT 0345 605 2069
Fig.L1
Fig.L3
Fig.L2
Fig.L4
MAINTENANCE
TO REPLACE THE LINE
5.1 To replace the spool and line complete
For your convenience it is recommended you buy spool and line
complete.
Remove old spool.(See. Fig. F1)
Place new spool into cutting head. Release one line from cleat
and feed line through eyelet.
Repeat for second line.
Refit the cap.
5.2 To replace the line only
WARNING: Your Trimmer is designed to use only line with a
maximum diameter of 2.0mm
IMPORTANT - Always wind the line onto the upper section
of the spool first.
Take approximately 2.5m of line.
Insert 1.25m of line into one of the holes in the upper section of
the spool and wind line in the direction of the arrows on the top
of the spool.Leave approximately 1.25m of line unwound and
place into cleat. Repeat on lower section of spool. (See. Fig. L1,
L2, L3, L4)
Care should be taken to ensure that the line is neatly coiled on
the spool. Failure to do so will impair the efficiency.
Then fit spool as described in “5.1 To fit spool and line complete”.
5