Instruction Manual

AFTER SALES SUPPORT 0345 605 2069

REPLACE THE TRIMMER HEAD WITH THE 3-TEETH

BLADE (THE TRIMMER HEAD IS FIXED IN THE TOOL IN

THE ORIGINAL PACKING )

Insert and keep the shaft lock rod into the hole of trimmer head

and loosen the trimmer head by screwing it clockwise. Take

away the trimmer head. (See Fig. F1)

1) Stick the stop rod (22) into the hole on the side of trimmer

head.

2) Loosen the trimmer head by clockwise.

3) Take away the trimmer head.

First Keep the lower plate(c) stay on the tool, take away the

upper plate(d). (See Fig. F2)

Then, put the 3-teeth blade, upper plate, Blade nut cover,

locking nut on the tool in proper order. Tighten the locking nut.

(See Fig. F3)

1)Install the checking ring following the sketch map.(see Fig F4 )

NOTICE:If you don’t match the tooth proﬁle, wheel gear may

damage, you will hurt somebody.

2)Put the step surface away from the blade. (see Fig F4 F5 )

NOTICE: If you don’t put the bigger side on the surface of

blade, blade can’t be press completely, you will hurt somebody.

3)Insert the bolt cover. (see Fig F5)

NOTICE: Keep the front opening to the earth.The cover’s

function is protecting the bolt from damage.

WARNING: The bolt cover can protect the bolt from damage. If

you damage the bolt, you can not change your blade.

4)Use the shaft lock rod insert into the hole on the side of work

head.

Then use the Hex wrench tighten the screw after we ﬁx the

work head. (see Fig F6)

NOTICE: To protect against injury, you have to wear gloves

prior to any operation with the 3-teeth blade. The blade have

two side cutting function customers can turn-over the blade to

use again.

NOTICE: Assembling the upper plate in the direction as Fig.F3.

Use hex wrench to fasten the locking nut by anticlockwise.

ASSEMBLY

Fig.F1

Fig.F2

c d

Fig.F3

dc 20 21 22

Fig.F4

Fig.F5

Fig.F6