Instruction Manual

17
AFTER SALES SUPPORT 0345 605 2069
ADJUSTING CUTTING LINE LENGTH
The trimmer head allows the operator to release more cutting
line without stopping the motor. As line becomes frayed or worn,
additional line can be released by lightly tapping (See. Fig. E1) on
the ground while operating the trimmer (See. Fig. E2)
NOTICE: Line release will become more difficult if the line cutter
becomes too dull.
NOTICE: The original line length is 330mm. There are two kinds
of cutting width When the line cutter is mounted on the location
as Fig. E3, the cutting width is 330mm. When the line cutter is
mounted on the location as Fig. E4, the cutting width is 380mm.
WARNING: Do not remove or alter the line cutter blade
assembly. Excessive line length will be cutted to suitable
length.
ASSEMBLY
5
Fig.E1
Fig.E3
330mm
Fig.E4
380mm
Fig.E2