Instruction Manual

22 23AFTER SALES SUPPORT 0345 605 2067 AFTER SALES SUPPORT 0345 605 2067
ASSEMBLY
Installing or removing battery pack
i. Hold the tool and the battery pack firmly when installing
or removing the battery pack. Failure to hold the tool
and the battery pack firmly may cause them to slip
off your hands and result in damage to the tool and
battery pack, potentially causing a personal injury.
ii. Always switch off the tool before installing or removing
the battery pack.
iii. To remove battery pack, press the release button, and
pull out. To install the battery pack, align the tongue on
the battery pack with the groove in the housing and
slip it into place. Always insert it all the way until it locks
in place with a little click. If not, it may accidentally
fall out of the tool, causing injury to you or someone
around you.
NOTE: Do not use force when installing the battery
pack. If the battery pack does not slide in easily, it is
not being inserted correctly.
WARNING : Verify that the switch is in the OFF
position before inserting or removing the battery
pack.
WARNING : Verify that the battery pack is removed
and the switch is in the OFF position before
inspecting, adjusting or performing maintenance on
any part of the chain saw.
4
ASSEMBLY
Press the battery capacity level button to check the charging level of the battery pack. The status /
remaining charge will be shown on the battery charging level indication light.
3 Green LEDs continuously lit Battery pack fully charged
2 Green LEDs continuously lit Battery pack 65% charged
1 Green LED continuously lit Battery pack 35% charged
No LED lit Battery is dead and needs to be charged
Charge the battery pack before operating when it is at
medium or low battery charging level.
WARNING : Read, understand and follow the
instructions contained in the section entitled charging
procedure.
NOTE : The battery pack comes partly charged. Charge the battery pack prior to
rst use, ideally at least 60 minutes.
. Always pull out the plug of charger from the mains before removing or connecting
the battery pack to the charger.
. Never charge the battery pack when the ambient temperature is below 5 °C or
above 40°C.
. Never recharge a battery pack again immediately after rapid charging. This could
overcharge the battery pack, thus reducing the lifespan of the battery pack and
charger.
. Rest the charger for at least 15 minutes between continuously charging sessions.
. If no battery pack is inserted into the charger and the charger is connected to
mains, the charging status LED shows red.
Checking battery capacity
Charging the battery pack
5
6
button
LED