Instruction Manual

24 25AFTER SALES SUPPORT 0345 605 2067 AFTER SALES SUPPORT 0345 605 2067
MAINTENANCE
WARNING! Always switch the product off, disconnect
it from the power supply and let the product cool
down before performing inspection, maintenance and
cleaning work!
i. Keep the underbody and cutting blade clean and free of
debris. Remove clippings from the discharge chute.
ii. Check all nuts and bolts periodically for tightness before
operation. After prolonged use, especially in sandy soil
conditions, the cutting blade will become worn and lose
some of its original shape. The cutting efficiency will be
reduced and the cutting blade should be replaced.
iii. Lubricate the cutting blade after each use to prolong
the life span of the cutting blade and product. Apply light
machine oil along the edge of the cutting blade.
Replacing the cutting blade
Keep the cutting blade sharp to ensure a good cutting
performance. Replace a worn or damaged cutting blade
with a new one of the same type or have it sharpened by a
qualified specialist.
i. Loosen the bolt anti-clockwise using a suitable wrench
and remove it together with the blade.
ii. Replace the blade with a new one of the same type.
iii. Reattach the blade onto the spindle, pay attention to
correct alignment. Tighten the bolt clockwise with 18
Nm min, 22 Nm max. to ensure safe operation of your
product.
NOTE: Replace this cutting device after 50 hours mowing or 2 years
whichever is sooner regardless of condition. If the cutting device is
cracked or damaged, immediately replace it with a new one.
MAINTENANCE
Repair
This product does not contain any parts that can be repaired by
the consumer. Contact an authorised service centre or a similarly
qualified person to have it checked and repaired.
Power cord
If the power cord is damaged, it must be replaced by the
manufacturer.
Storage
• Switch the product off and disconnect from power supply.
• Clean the product with a soft damp cloth. Be aware blades
are sharp. Use protective gloves when cleaning.
Transportation
• Switch the product off and disconnect from power supply.
• Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
• Secure the product to prevent it from slipping or falling
over.