Install Sheet

[e-mail] 02.22.19
|
92-WB-WKF-02
INSTALLATION GUIDE: WIDESPREAD KITCHEN FAUCET
CALIFORNIA PROPOSITION 65:
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information go to www. P65Warnings.ca.gov.
Wash hands after installation, repair, or removal of this product.
1
1
8
"
MIN
1
1
2
"
MAX
8”
4” MIN
TURN OFF WATER SUPPLIES.
Ensure mounting surface requirements are
as follows:
• With Spray - Four (4) Holes;
4" on center, Ø 1-1/8" Min to Ø 1-1/2" Max.
• Surface Thickness 1-1/8” Max
1
SIDE SPRAY HOSE INSTALLATION
(IF EQUIPPED)
• Mount Spray Hose Holder onto sink and
secure with Hose Holder Nut.
• Insert Spray Hose into Hose Holder.
• From bottom side of sink, insert end of Spray
Hose through center mounting hole of sink.
• Assemble Spray Hose to Faucet and tighten.
(DO NOT OVER TIGHTEN CONNECTIONS).
2
MOUNT UNIT ON SINK BASIN.
Position Faucet and Putty Plate on sink.
Assemble Mount Washers and Locknuts onto
Faucet Shanks and tighten. (DO NOT OVER
TIGHTEN LOCKNUTS).
3
ASSEMBLE WATER SUPPLY LINES.
Use ½” IPS faucet connections (not
supplied). Use wrenches to tighten
connections. Do not overtighten.
Caution: Use wrench or pliers to hold faucet
inlet adapters when tightening supply line
nuts to prevent twisting copper tubing or
damaging solder joints.
4
TURN ON WATER AND FLUSH
THE SYSTEM.
Remove aerator (if installed) using aerator key
and flush thoroughly to remove any debris.
Re-install aerator.
5
CONFIRM PROPER INSTALLATION
Check for leaks and proper operation of
faucet.
6
Accepts a 3/8”
Compression
Fitting
*SUPPLY STOPS NOT INCLUDED
1
4
3
2
5
4
INLET SUPPLIES
NOT INCLUDED