Installation Guide

INSTALLATION GUIDE: WIDESPREAD MOUNTED
LAVATORY FAUCET
[e-mail] 02.22.19
|
92-WB-WLF-02
CALIFORNIA PROPOSITION 65:
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information go to www. P65Warnings.ca.gov.
Wash hands after installation, repair, or removal of this product.
ASSEMBLE WATER SUPPLY LINES.
Connect Widespread Hoses from bodies to
Spout Tee and tighten. Connect water
supply lines to valve bodies and tighten.
4
PREPARE AND INSTALL
POP UP DRAIN ASSEMBLY
When assembling pop-up drain assembly to
sink, apply plumbers putty to bottom of
flange, silicon sealant between mack
washer and threads. Apply thread sealant
to tailpiece threads.
5
PREPARE AND INSTALL
LIFT ROD DRAIN ASSEMBLY
From beneath, insert Drain Assembly
through drain hole in sink. Attach supplied
Flange Washer or plumber’s putty to the
underside of the Flange. Secure Flange to
the Drain Assembly. From beneath, tighten
mounting nut. Place one end of Spring Clip,
on Pivot Rod. Insert Pivot Rod through a hole
in the Lift Rod Strap. Secure with Spring
Clip. Place Drain into the open position by
pressing downward on the Pivot Rod. Insert
Lift Rod into Strap. Adjust height of Lift Rod,
and tighten Thumb Screw.
5
TURN ON WATER AND FLUSH
THE SYSTEM.
Remove aerator (if installed) using aerator key
and flush thoroughly to remove any debris.
Re-install aerator.
6
CONFIRM PROPER INSTALLATION
Check for leaks and proper operation of faucet.
7
OR
Accepts a 3/8”
Compression
Fitting
*SUPPLY STOPS NOT INCLUDED
1
4
POP UP DRAIN ASSEMBLY
5
6
LIFT ROD DRAIN ASSEMBLY
5
4