Installation

800-537-2107
www.speakman.com
NEED HELP?
For additional assistance or service please contact:
92-VS-128-01
VS-126/VS-128
INSTALLATION INSTRUCTIONS
2 Position Wall Mount
Hand Shower Bracket
TOOLS & SUPPLIES NEEDED
Pencil Phillips
Screwdriver
Drill
Ø 3/16”
Drill Bit
Eye Protection
IMPORTANT
MAINTENANCE
SAFETY TIPS:
Be sure to read and understand all instructions
before beginning installation.
Inspect all connections after installation.
Cover the drain to avoid loss of parts.
Be sure to wear proper eye protection.
Do NOT over tighten any connections or damage
may occur.
Observe all local plumbing and building codes.
Periodic cleaning using a mild soap and warm
water will help keep your product's appearance in
its original condition.
For best results, dry immediately with a soft, clean
cloth. DO NOT USE harsh and/or abrasive
cleaners.
To help restore the finish, occasionally apply a
non-abrasive wax to your product (follow
manufacturers’ instructions).
On CHROME PLATED PRODUCTS, a two (2) part
white vinegar, one (1) part water solution can be
used to break down excessive mineral deposits. Let
the product soak in the solution for about ½ hour
then rinse thoroughly. Brush off any remaining
mineral deposits if necessary.
DO NOT USE the vinegar/water treatment on any
finish other than Chrome.
MARK MOUNTING LOCATION
1
Position Bracket vertically on wall, ensuring
your hand shower hose can reach the
location. Mark mounting screw locations
with a Pencil.
DRILL MOUNTING HOLES
2
If mounting directly to wood stud, Plastic
Anchors are not required. If mounting to
drywall or tile, select appropriate Ø 3/16"
Drill Bit and Drill guide holes at marked
locations
Ø 3/16”
INSTALL ANCHORS
3
Insert supplied Anchors into previously
drilled holes.
SECURE BRACKET
4
Secure Hose Bracket to Anchors using a
Phillip’s Head Screwdriver.