Installation Guide

INSTRUCTIONS FOR MODELS
92-VS-159-01
For additional assistance or service please contact:
SPEAKMAN
®
800-537-2107
[e-mail]
www.speakman.com
VS-159
TOOLS AND SUPPLIES
IMPORTANT
SAFETY TIPS
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
MAINTENANCE
Your new Speakman product is designed for years
of trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool, and harsh chemicals
as these will dull the finish and void your warranty.
WARRANTY
Warranty information can be found at:
www.speakman.com
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
Drill
3/8“ Hex
Key Wrench
(not included)
1” Hole Saw
Thread Seal
Tape
2mm Hex Key
Wrench (included)
Silicone Caulk Gun
1
Drill 1” diameter hole in wall.
Ø 1”
2
Apply Thread Seal Tape (not included) around Adapter Pipe
threads then screw Adapter Pipe into existing Supply Pipe Coupling
behind the wall. Tighten with 3/8” Hex Key (not included).
• Adapter pipe should be 7/8” to 1” from the finished wall.
• Turn on water supplies and check for leaks.
1/2"-14NPT
WATER INLET
(NOT SUPPLIED)
INSIDE THE WALL
7/8”-1”
3/8”
3
Slide Escutcheon over the Supply Elbow as far
back as it will go.
4
Slide Supply Elbow over the Pipe Adapter.
Center the Outlet port on the wall. Outlet port
should be pointing downward when complete.
• Tighten Set Screws (both top and bottom) with
2mm Hex Key Wrench included.