Installation Guide

8 PIPE ADAPTER INSTALLATION
• Apply Teflon tape to both sides of Pipe Adapter then thread into Rain
Shower Ball.
• Pull the Flexible Hose through the cut-out in the Cross-Brace and thread to
the other end of the Pipe Adapter.
• Wrench tighten connections.
“A”
PIPE ADAPTER TO
RAIN SHOWER HEAD
A
B
“B”
SUPPLY HOSE TO
PIPE ADAPTER
9 RAIN SHOWER HEAD INSTALLATION
1 Lift the Rain Shower Assembly into the ceiling frame, aligning the Pipe Adapter through the cut out in the Cross Brace.
2 Slide the Rain Shower Assembly with Pipe Adapter into the slot to lock the assembly in place.
3 Tilt the Rain Shower Head into place, ensuring that the rubber seal around the flange is flush and properly seals against the
Shower Head.
• Turn on water supplies and check for leaks.
VS-127 ROUGH-IN DIAGRAM
SPEAKMAN
®
DIMENSIONS SUBJECT TO CHANGE WITHOUT NOTICE.
NOTES:
Contractor to supply all necessary framing
and plumbing connections.