Specifications

THIS SPACE FOR ARCHITECT/ENGINEER APPROVAL.
400 ANCHOR MILL ROAD | NEW CASTLE, DE 19720
P: 800-537-2107 | F: 800-977-2747
WWW.SPEAKMANCOMPANY.COM
REVISION DATE: JANUARY 2014
SPECIFICATION
16
NOTE: 1. All dimensions are in inches (millimeters) unless otherwise specified and are
subject to change without notice.
Management Systems
Registered to ISO 9001
SPEAKMAN
®
Vintage™Showerhead S-2255
Instructions for Models:
S-2255
Need Help?
For additional assistance or service call:
SPEAKMAN Company
400 Anchor Mill Road
New Castle, DE 19720
PHONE: [phone]
EMAIL: [e-mail]
WEB: www.speakmancompany.com
92-S-2255-R1
What You Need To Know:
Tools:
Required:
*Teflon Tape *Adjustable Wrench
Important Notes:
Be sure to read instructions thoroughly before
beginning installation. Do not overtighten any
connections or damage may occur.
Safety Tips:
Cover your drain to prevent loss of parts.
Maintenance:
Periodic cleaning using a mild soap and warm
water will help keep your showerhead’s
appearance in its original condition.
For best results, dry immediately with a soft,
clean cloth. DO NOT USE harsh and/or abrasive
cleaners.
To help restore the finish, occasionally apply a
non-abrasive wax to your showerhead body
(follow manufacturers’ instructions).
On CHROME PLATED SHOWERHEADS, a
two (2) part white vinegar, one (1) part water
solution can be used to break down excessive
mineral deposits on the sprays. Let the showerhead
soak in the sol
ution for about ½ hour then rinse
thoroughly. Brush off any remaining mineral
deposits if necessary.
DO NOT USE the vinegar/water treatment on
all special finishes (-BN, -ORB, -PN, -PB).
To reduce mineral build-up, turn the handle to
FLOOD position to let the water drain out after
every use.
Warranty:
Warranty information can be found at:
www.speakmancompany.com
①
②
Apply Teflon Tape to the outlet side of shower
arm in a clockwise direction.
Thread Showerhead onto shower arm by turning
it in a clockwise direction. Tighten with adjustable
wrench. Turn water supply on and check for leaks.
Specifications:
Inlet: 1/2” NPT FEMALE
4.8in
121mm
4.2in
106mm
3.4in
87mm