Installation

INSTRUCTIONS FOR MODELS
92-SF-8700-01
For additional assistance or service please contact:
SPEAKMAN
®
800-537-2107
[e-mail]
www.speakman.com
SF-8700
SF-8800
SF-8702
SF-8802
* YOUR FAUCET MAY DIFFER IN APPEARANCE
TO ITEM SHOWN, IT WILL INSTALL WITH IN
THE SAME MANNER.
TOOLS AND SUPPLIES
Adjustable
Wrench
Phillips
Screwdriver
Pencil
Aerator
Wrench
(included)
Tor x Bit
(Included)
Bit Driver
Warranty information can be found at:
www.speakman.com
WARRANTY
MAINTENANCE
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
• This faucet has an operating range of 20-80 psi.
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives may damage the finish and
void the product warranty. Please be sure to only use
approved cleaners. Please contact Speakman for any
clarification of acceptable cleaners.
1
Remove Mounting Hardware (1) from faucet.
Verify that the Rubber Gasket (2) is in position
and aligned to the base of the faucet.
NOTE: If an AC Adaptor is being used, locate
the AC Connector Cable (Green) (3) inside the
faucet body and pull the connector out.
2
Place Hose carefully, one at a time, thru hole in
mounting surface. Lower Faucet into position.
3
From below, install Rubber Washer (1), Metal
Washer (2), and secure with Mounting Nuts (3).
Align Faucet to desired position and wrench
tighten Mounting Nuts (3).
4 SINGLE INLET HOSE
(SF-8700 & SF-8800)
Ensure the water supplies are turned off.
For Model SF-8700 & SF-8800: Uses a
Single Hose Mixed inlet. Attach the Hose of the
Faucet to a water supply. Wrench Tighten.
TO
WATER
SUPPLY
5 DOUBLE INLET HOSES
(SF-8702 & SF-8802)
Ensure the water supplies are turned off.
For Model SF-8702 & SF-8802: Uses two
hoses as shown below. Make connections with
the Hot and Cold hoses of the faucet to water
supplies. The inlet threads of the faucet are
9/16”-24 UNF and will accept a 3/8”
Compression Fitting. Wrench Tighten.
Accepts a 3/8”
Compression
Fitting
SUPPLY STOPS NOT INCLUDED
6 FOR BATTERY MODEL
(SF-8700 & SF-8702)
Use the provided Torx Bit tool to release the two
(2) Screws (1) and slide up to open the Lid (2) .
NOTE:
Be sure to cover your drain.
7 FOR BATTERY MODEL (SF-8700 & SF-8702)
Disconnect the GREEN Connector (1) and pull out the Battery Box (2).
8 FOR BATTERY MODEL (SF-8700 & SF-8702)
Push to release the Battery Box Cover (1). Insert or replace the batteries with six (6) new standard 1.5v AA
batteries (2). Ensure the position of the new batteries are aligned to the plus (+) and minus (-) symbols within
the battery holder.
9 FOR BATTERY MODEL (SF-8700 & SF-8702)
Install the Battery Box Cover (1) and reconnect the GREEN Connector (2). Make sure the cover is fully pressed in.