Installation

Before installing aerator, turn on both hot and cold faucet
handles. This will clear out any debris from the supply lines.
Close both hot and cold faucet handles. The aerator can now be
installed. Tighten first by hand, followed by the supplied aerator
wrench.
Tighten both supply connections. Open both supply valves and
check for leaks.
Connect the short blue hose from the tee to the cold supply valve, and
the red (hot) supply hose to the hot supply valve.
7
8
9
10
HOT
COLD
NOTE: If shut off valves are installed in the supply line of the eyewash,
provisions shall be made to prevent unauthorized shut off.