Installation

SPEAKMAN
®
PO Box 191 Wilmington, DE 19899 Phone: [phone] Fax: [phone]
Visit us on the web at www.speakmancompany.com
9/10
92-2368
5. veR 6 fo 4 egaP
INSTALLATION
Step 1: Gooseneck Removal-
a. Verify the water is shut-off to the unit
b. Remove the old gooseneck unit. Clean mounting surface.
Step 2: Gooseneck Eyewash Mounting-
a. Slip the base washer onto the gooseneck eyewash and
slip through the center hole of the sink or countertop.
b. The gooseneck eyewash swivels through 200° of rotation.
Position the base of the gooseneck eyewash so the
setscrew hole in the base is pointing towards the back of
the sink or countertop. Note- For rigid gooseneck,
position the gooseneck and tighten the setscrew in the
mounting base. From below the sink, slip the cup washer
onto the shank and use the nut to tighten the assembly
down onto the sink or countertop.
c. Important- Next insert the rubber seal into the adapter
and screw the adapter onto the shank of the gooseneck
eyewash until it bottoms out (Tape may be applied to the
shank). If the adapter needs to be positioned for hose
attachment, it can be backed off up to a maximum of 1 / 2
turn.
Step 3: Hose Connections-
a. The inlets to the base adapter accept 3/8”
compression fittings. The SEF-1000 comes
standard with 3/8” compression to hoses to
mount to standard Speakman Co. valve end
bodies (part nos. G20-2007/G20-2008)
b. Screw valve body hoses onto the side outlets
of the valve bodies and tighten. Screw the
other end of the hoses onto base adapter.
c. Connect the vertical inlet of the tee to the cold
water inlet supply.
d. Connect the hot & cold water supply lines to the
inlets of the valve bodies and tighten the coupling
nuts.