Installation

SPEAKMAN
®
400 Anchor Mill Rd. New Castle, DE 19720 Phone: [phone] Fax: [phone]
01/05/18 speakman.com 92-2733-09
3. Attach eye/face wash to lower arm by threading assembly into encased tee. Be sure to use a
thread sealant to guard against leaks. Fasten push handle to spindle extension on lower arm.
Screw is located in extension.
NOTE: To prevent water spillage and potential slipping hazards at shower location. It is recommended
to connect proper drainage piping to the 3/8” NPT outlet on the freeze protection valve located on the
eyewash arm. If a flexible type hose is used, be careful to avoid kinking in the hose, which in turn may cause
a frozen blockage.
4. Apply a thread sealant and attach shower head to 1" nipple on upper shower arm. Fasten lever
handle with screw located in extension. Secure pull rod to lever handle.
PLUMBING NOTES
1. The primary function of this unit is to keep water from freezing.
2. When possible, install unit in an area protected from direct blast of prevailing winter winds, to
minimize wind chill factor.
3. BE SURE WATER SUPPLY PIPING IS PROTECTED FROM FREEZING.