Installation

INSTRUCTIONS FOR MODELS
92-SE-573-02
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
[e-mail]
www.speakman.com
SE-573 (ADA COMPLIANT)
SE-573-SD
TOOLS AND SUPPLIES
Drill
Drill Bit
1”
Drill Bit
1/4”
Slip Joint
Wrench
Measuring
Tape
Pencil
Pipe
Wrench
Additional warranty information can be found at:
www.speakman.com
WARRANTY
MAINTENANCE
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
• This unit should be connected to an uninterrupted
source of potable water, with a minimum flowing
pressure of 30 PSI and a maximum static pressure
of 125 PSI
• Note: All units meet existing ANSI Z358.1
Standards and OSHA Rules. Product improvements
may cause specification and dimensional changes
without notice.
The valve, eye/face wash spray heads, and O-rings are
the only portions of the unit that may require
maintenance. Should you need parts to repair this unit,
please reference the parts within this document for the
correct part required. Before any maintenance is
done, be sure to shut the water supply off
1
Review Rough In drawing and determine
mounting location. Measure and layout
required mounting holes as shown below.
Ensure centerlines of holes are square and
perpendicular to sink. Drill mounting holes
through counter-top. Counter-top thickness
not to exceed 3”.
1" 25mm
THRU HOLE
.250in 6mm
.25in [6mm] MIN
1" 25mm
1” ¼”
2
Install Eyewash through counter-top.
Eyewash Sprays should be facing away
from you. Ensure Alignment Post on
Mounting Flange ❶ is positioned into the
¼” hole. Secure into position with Washer
❷ , and nut ❸. Wrench tighten.
3
Connect a water supply to the unit that is a
minimum 1/2” uninterrupted source of
potable water. Failure to use potable
water can result in emergency units
producing impure or contaminated water
causing possible further injury. Plumbing
connections not included.
ACTIVATION AND TESTING
The eye wash is activated by pulling spray heads downward 90° over the sink basin. Once the unit is activated, water will discharge from the spray outlets
until the eye wash spray heads are manually pushed back to the vertical off position.
TESTING PROGRAM
The American National Standards Institute (ANSI) states that all safety emergency equipment shall be activated on a weekly basis to flush the line and verify
proper operation. Speakman Company furnishes a testing record tag (91-0635) with each unit. On this tag the date of inspection and the inspector’s initials
should be noted.